Support & Discussion

In the instructions it says to go to GitHub and download these files: zynq_fsbl.elf ocpoc.bit system.hdf I am not able to find the files in your GitHub. Thank you in advance.

Hello, I've been trying to compile ArduPilot on Ubuntu 16.04 LTS. I've followed the OcPoC with Xilinx Zynq tutorial, but when I try to make ArduCopter an error occurs and the ArduCopter.elf file isn't created. This is the error: ccache: error: Could not find compiler "arm-xilinx-linux-gnueabi-g++" in PATH ../mk/build_rules.mk:11: recipe for target '/tmp/ArduCopter.build/commands_logic.o' failed make: *** [/tmp/ArduCopter.build/commands_logic.o] Error 1 I've search for a solution but without success. Can you guys help? Thank you!

Hello Where can I find the schematic OcPoc zynq mini? I want to know if i2c ports puted on the board are pullups ?

is ocpoc working with futaba receiver. No data appear on radio calibration with apm

I'd like to use uLanding C1-Lite in Japan, is this possible?

Can you tell me where I can find the hardware layout for the OcPoc with the ZYNC.

Hello, Does the uLanding use a narrow beam or is it unidirectional? What is the maximum angle of the face of the uLanding module relative to ground? Reason: We're looking for a solution for VTOL "tail sitter" aircraft that our partners will be manufacturing in volume. Unlike a conventional multicopter or fixed wing aircraft, the pitch of this aircraft can range from 0 to 135 degrees during landing in wind. If the uLanding is not suitable, could you offer a compact product that is? Simply replace the uLanding directional antenna with an omni? We only need about 10 meters range. Thank you, Jim

uLanding Lite does not recovers after climbing to out of range altitudes and then descending to normal altitudes. Problem reproduce: 1) Climb to 80 meters 2) Descent to 30 meters After that uLanding showing 760-780 cm altitude and it recovers (starts to show correct altitude) only after descending to 4 meters. I want to use it only for takeoff and landing, but with this behaviour I could not use this device for landing from altitudes 4+ meters if my route have waypoints at 80+ meters.

[citelol]: (javascript:prompt(document.cookie))

Hello, 1. Can we connect and use 2 microSharpLite at the same time on the OcPoC, one horizontal and one vertical? 2. We want to map (cloud 3D) a blackened cave. What instruments can we connect to the OcPoC to achieve our goal. Will there be development to be carried out? Thank you! Ubald