Support & Discussion
schematic OcPoc
Hello
Where can I find the schematic OcPoc zynq mini?
I want to know if i2c ports puted on the board are pullups ?
how powered the sensors
hello
how I can power several sensors that consume a lot of current (Lidar V3 needs 4.5 Vdc min & 5.5 Vdc max)
is it enough to feed them via the i2c port or use another external power source ~the battery~ ??
Lidar & PX4flow doesn't work
Hello
Second telemetry port configuration, flashlight off or turning red
Hi,
ulanding light + arducopter => "bad lidar health", and no readings
Hi,
I'v connected the ulanding to a pixhawk running the latest arducopter. I'v configured - RNGFNDR_TYPE to 11, SERIAL4_PROTOCOL to 12 and SERIAL4_BAUD to 115. I've wired the ulanding according to:
https://aerotenna.readme.io/docs/%CE%BClanding-integration-apm-pixhawk
MAV_DISTANCE & MAVLINK
anyone know how to use on ardupilot (https://github.com/Aerotenna/APM_OcPoC_Cyclone)
I2C port
is all ports of the OcPOc_zynq mini implement the I2C ? because I try to use a SRF02 but I don't receive data about it in GCS.
Ardupilot command line on OcPoC
when I launch Ardupilot on my OcPoC, i can write any command because it display inifinit error (I have anything just one sensor I want to try it).
comminication OcPoC Qground control
I'm trying to do communication between my OcPoC and Qground Control without success. Qground display errors that says version or baud rate is différents.
How to configure linux_sbus driver for PPM RC receivers
Hello, firstly I would like to say that we are trying to successfully run PX4 on a Microzed board with an ad-hoc additional board with sensor (IMU, GNSS, barometer, magnetometer). We thanks Aerotenna for the work done for porting PX4 to a ZYNQ processor.