Support & Discussion
how powered the sensors
hello
how I can power several sensors that consume a lot of current (Lidar V3 needs 4.5 Vdc min & 5.5 Vdc max)
is it enough to feed them via the i2c port or use another external power source ~the battery~ ??
Lidar & PX4flow doesn't work
Hello
Second telemetry port configuration, flashlight off or turning red
Hi,
MAV_DISTANCE & MAVLINK
anyone know how to use on ardupilot (https://github.com/Aerotenna/APM_OcPoC_Cyclone)
I2C port
is all ports of the OcPOc_zynq mini implement the I2C ? because I try to use a SRF02 but I don't receive data about it in GCS.
RC seems not work well, what's wrong?
I connected Futaba RC(R2008SB), Dji's ESC and motors to your Zynq Mini Box based on guideline - https://aerotenna.readme.io/v1.0/docs/integrating-the-ocpoc-mini-zynq-into-a-pre-existing-airframe and then try to run px4 based on guideline - https://aerotenna.readme.io/v1.0/docs/px4-setup. It seems the system didn't work, I monitored PWM signal and found that no any change when I tried to control motor by RC radio. The RC radio and Dji's ESC/motors all worked well on my current Pixhawk platform. For Pixhawk platform, there is safty switch for arm and disarm (I didn't find it on Zynq Mini Box). Do I miss anything for Zynq Mini Box? Any comments?
Could you please help for the following issue (run PX4 on OcPoc Zynq box)?
We try to run PX4 on OcPoc Zynq platform. Could you please help for the following issue (run PX4 on OcPoc Zynq box)?
Can i use OcPoc hardware(Zynq) box with PX4 firmware to replace Pixhawk hardware(Cotex-M4F) with PX4 firmware?
Currently, i'm ongoing to use Pixhawk hardware with PX4 firmware on my aircraft. On my pixhawk platform, i used external Futaba RC, GPS etc. I want to know if i can use OcPoc hardware (Zynq) box with PX4 firmware to replace my current Pixhawk hardware (Cotex-M4F) with PX4 firmware. Thanks.
Where can i get hardware schematic of OcPoc board with Zynq?
Where can i get hardware schematic of OcPoc board with Zynq?
Where can i get PL logic codes such as PWM, CSI etc. ? Thanks a lot!
We want to add some own logic functions in PL. Where can i get your PL logic codes such as PWM, CSI etc. (or overall PL project that can be opened by ISE or Vivado)? Thanks a lot!